ROOM TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the cooler thermistor (room temperature sensor) removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B000WAX

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  2. REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)


    1. B000WF1

      Detach the claw and remove the cooler thermistor (room temperature sensor) from the instrument panel safety pad sub-assembly.

    2. B000W6CC01
      B000WYJ Remove in this Direction

      Pull out the cooler thermistor (room temperature sensor) through the gap as shown in the illustration.

    3. B000YLJC01
      B000XM7 Aspirator
      B000TT4 Connector

      Disconnect the Aspirator and connector and remove the cooler thermistor (room temperature sensor).