REAR SEAT INNER BELT ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT REAR NO. 1 SEAT INNER BELT ASSEMBLY LH


    1. B000XF0C03
      *a

      Component without harness connected

      (Rear No. 1 Seat Inner Belt Assembly LH)

      Check the buckle switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (LBR+) - 1 (LBR-) Seat belt fastened (Buckle switch is on) 10 kΩ or higher
        2 (LBR+) - 1 (LBR-) Seat belt unfastened (Buckle switch is off) Below 1 Ω
        If the result is not as specified, replace the rear No. 1 seat inner belt assembly LH.

  2. INSPECT REAR SEAT INNER BELT ASSEMBLY RH


    1. B000XF0C04
      *a

      Component without harness connected

      (Rear Seat Inner Belt Assembly RH)

      Check the buckle switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (RBR+) - 1 (RBR-) Seat belt fastened (Buckle switch is on) 10 kΩ or higher
        2 (RBR+) - 1 (RBR-) Seat belt unfastened (Buckle switch is off) Below 1 Ω
        If the result is not as specified, replace the rear seat inner belt assembly RH.