REAR SEAT INNER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH


    1. B000WGDC01
      *a Protruding Part
      B000XM7 Bolt
      B000TT4 Connector

      Pass the wire harness and connector of the rear No. 1 seat inner belt assembly LH through the hole on the quarter trim panel assembly LH.

      Note

      Take care not to damage the wire harness and connector.

    2. Install the rear No. 1 seat inner belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the anchor part of the rear No. 1 seat inner belt assembly LH to overlap the protruding part.

    3. Connect the connector.

  2. INSTALL QUARTER INSIDE TRIM BOARD LH

    Click here

  3. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  4. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  5. INSPECT SEAT BELT WARNING SYSTEM

    Click here