FRONT SEAT INNER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat inner belt assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front seat assembly LH (Only for removal and installation)

  • Front seat assembly RH (Only for removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B000ZBZ

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY

    Click here

  3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Seat)


    1. B000WN2

      Detach the wire harness clamps and disconnect the 2 connectors.

    2. Detach the claw and remove the connector from the front seat cushion wire harness holder LH.

    3. B000YWK

      Detach the wire harness clamps.

    4. B000YTF

      Remove the nut and front seat inner belt assembly LH.

    5. B000VEG

      Remove the front seat belt anchor plate.

  4. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Seat)


    1. B000YS5

      Detach the rubber band of the separate type front seatback cover from the 2 hooks.

    2. B000UUY

      Detach the claw and remove the connector.

    3. Disconnect the 2 connectors.

    4. Detach the wire harness clamps.

    5. B000X5T

      Detach the wire harness clamps.

    6. B000WZY

      Remove the nut and front seat inner belt assembly RH.

    7. B000VPS

      Remove the front seat belt anchor plate.