SEAT HEATER CONTROL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the seat heater control sub-assembly LH removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA system	Click here
		Pre-collision system	Click here
		Parking assist monitor system	Click here
	Steering sensor zero point calibration	Variable gear ratio steering system	Click here
Front seat assembly LH (Only for removal and installation) Front seat assembly RH (Only for removal and installation)	Initialize position control ECU	Front Power Seat Control System	Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click here
REMOVE FRONT SEAT ASSEMBLY LH

Click here
REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH
1. Remove in this Direction
  
  Protective Tape
  
  Disconnect the connector.
2. Using a thin-bladed screwdriver, detach the claw.
  
  Tech Tips
  
  Tape the thin-bladed screwdriver tip before use.
3. Slide in the removal direction shown in the illustration and remove the seat heater control sub-assembly LH.

	Remove in this Direction
	Protective Tape