FRONT POWER SEAT MOTOR ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power seat motor assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front seat assembly LH (Only for removal and installation)

  • Front seat assembly RH (Only for removal and installation)

  • Front seatback frame sub-assembly LH (Including removal and installation)

  • Front seatback frame sub-assembly RH (Including removal and installation)

  • Front seat adjuster assembly LH (Including removal and installation)

  • Front seat adjuster assembly RH (Including removal and installation)

  • Power seat tilt motor assembly LH (Including removal and installation)

  • Power seat tilt motor assembly RH (Including removal and installation)

  • Power seat lifter motor assembly LH (Including removal and installation)

  • Power seat lifter motor assembly RH (Including removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B000ZBZ

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Seat)

    Click here

  4. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Seat)

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  6. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

    Click here

  7. REMOVE LIMIT SWITCH ASSEMBLY

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD (for Standard Seat Type)

    Click here

  10. REMOVE FRONT SEAT CUSHION PAD WITH COVER LH (for Sports Seat Type)

    Click here

  11. REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH

    Click here

  12. REMOVE RECLINING ADJUSTER INSIDE COVER LH

    Click here

  13. REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY LH

    Click here

  14. REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER LH

    Click here

  15. REMOVE POWER SEAT LIFTER MOTOR ASSEMBLY LH


    1. B000XUUC01
      *a Plate
      B000XM7 Nut
      B000TT4 Spacer

      Remove the 3 nuts, plate and spacer.

    2. Remove the power seat lifter motor assembly LH.

      Note


      • Remove at the lifter uppermost position.

      • The upper frame of the front seat adjuster assembly LH will quickly drop to the lowermost position if the power seat lifter motor assembly LH is removed. Therefore, when removing the power seat lifter motor assembly LH, support the upper plate of the front seat adjuster assembly LH with your hand.

      • Do not damage or dirty the gears or of the power seat lifter motor assembly LH and front seat adjuster assembly LH.

  16. REMOVE POWER SEAT TILT MOTOR ASSEMBLY LH


    1. B000VIY

      Remove the 3 bolts and power seat tilt motor assembly LH.

      Note

      Do not damage or dirty the gears or of the power seat tilt motor assembly LH and front seat adjuster assembly LH.