POWER SEAT SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power seat switch LH removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front seat assembly LH (Only for removal and installation)

  • Front seat assembly RH (Only for removal and installation)

  • Power seat switch LH (Including removal and installation)

  • Power seat switch RH (Including removal and installation)

Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B000ZBZ

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  3. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  4. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  5. REMOVE RECLINING POWER SEAT SWITCH KNOB

    Click here

  6. REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET LH

    Click here

  7. REMOVE SWITCH BEZEL


    1. B000W5BC01
      B000WYJ Remove in this Direction

      Remove the 2 screws.

    2. Detach the claw and remove the switch bezel together with the front power seat switch LH.

  8. REMOVE FRONT POWER SEAT SWITCH LH


    1. B000W0N

      Remove the 4 screws and front power seat switch LH from the switch bezel.