PRE-COLLISION SYSTEM WARNING BUZZER INSTALLATION

PROCEDURE

1. INSTALL SKID CONTROL BUZZER (PRE-COLLISION CITY BUZZER)

   Note

   If the skid control buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.

   
   

   1. 

      Connect the connector.

   2. Attach the clamp to install the skid control buzzer (pre-collision city buzzer) to the vehicle body.

2. INSTALL HEATER TO REGISTER CENTER SUB DUCT

   Click here

3. INSTALL NO. 2 AIR DUCT

   Click here

4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

6. INSTALL NO. 2 DECK BOARD

   Click here

7. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

8. CHECK SRS WARNING LIGHT

   Click here