PRE-COLLISION SYSTEM WARNING BUZZER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, initialization or registration) that must be performed after parts are removed, installed or replaced during the skid control buzzer (pre-collision city buzzer) removal/installation are shown below.

PROCEDURE

1. PRECAUTION

   CAUTION:

   Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

   Click here

   

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

   Tech Tips

   When the cable is disconnected/reconnected to the negative (-) battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

2. REMOVE NO. 2 DECK BOARD

   Click here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Click here

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   

   Click here

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

5. REMOVE NO. 2 AIR DUCT

   Click here

6. REMOVE HEATER TO REGISTER CENTER SUB DUCT

   Click here

7. REMOVE SKID CONTROL BUZZER (PRE-COLLISION CITY BUZZER)

   
   

   1. 

      Detach the clamp and remove the skid control buzzer (pre-collision city buzzer) from the vehicle body.

   2. Disconnect the connector.

      Note

      If the skid control buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.