FRONT FLOOR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B000Y52

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • B000VJQ

        If this procedure is performed without disconnecting the negative (-) battery terminal of the battery, the airbag may deploy even if an impact is applied only to the side airbag sensor assembly LH. Therefore, make sure that the negative (-) battery terminal of the battery is disconnected before performing this procedure.

    3. Turn up the front floor carpet.

    4. Attach the guide to hold the side airbag sensor assembly LH in place.

    5. Install the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor assembly LH has been dropped, replace it with a new one.

      • When installing the side airbag sensor assembly LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the nut while holding the side airbag sensor assembly LH because the side airbag sensor assembly LH guide is easily damaged.

    6. Check that there is no looseness in the installation parts of the side airbag sensor assembly LH.

    7. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

        B000W2FC14
        *a Correct *b Incorrect
        *c CPA *d Housing

      2. While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

        B000YLRC01
        *a CPA *b CPA Upper Part
        *c Connection is Completed - -
        B000WYJ Connect in this Direction - -

    8. Make sure that front floor carpet is returned to its original position.

  2. INSTALL NO. 1 SIDE TRIM BRACKET

    Click here

  3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH(FLOOR ANCHOR)

    Click here

  4. INSTALL OUTER LAP BELT ANCHOR COVER

    Click here

  5. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  6. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here

  9. INITIALIZATION OF SEAT ECU

    Click here