POP UP HOOD LIFTER(for Rear Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL NO. 2 POP UP HOOD LIFTER ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B000Y52

    3. Install the No. 2 pop up hood lifter assembly LH with the 2 nuts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    4. Attach the clamps.

    5. Connect the No. 2 pop up hood lifter assembly LH connector.


      1. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

        B000VQ8C05
        *a Correct *b Incorrect
        *c CPA *d Housing
      2. B000WV7C02
        *a Housing Lock
        *b CPA
        *c CPA Upper Part
        B000WYJ Connect in this Direction

        While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the No. 2 pop up hood lifter assembly LH connector.

  2. INSTALL NO. 3 COWL TOP PANEL INSULATOR (for LH Side)

    for LHD:

    Click here

    for RHD:

    Click here

  3. INSTALL NO. 2 COWL TOP PANEL INSULATOR (for RH Side)

    for LHD:

    Click here

    for RHD:

    Click here

  4. INSTALL FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP LH

    Click here

  5. INSTALL LOWER RADIATOR AIR DEFLECTOR

    Click here

  6. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH

    Click here

  7. INSTALL RADIATOR SUPPORT TO FRAME SEAL RH

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  9. INSTALL NO. 2 DECK BOARD

    Click here

  10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  11. CHECK SRS WARNING LIGHT

    Click here