CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the curtain shield airbag assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front Seat Assembly RH (Only for removal and installation)

  • Front Seat Assembly LH (Only for removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B000WAX

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    CAUTION:

    B000WHLC01
    B000WCG Deployment Side

    • When storing the curtain shield airbag assembly LH, keep the airbag deployment side facing upward.

    • If the airbag deploys for any reason, it may cause a serious accident.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B000Y52
    3. B000TYEC02
      *a Lock Button
      B000WYJ Release in this Direction
      B000WCG Protective Tape

      Using a screwdriver, release the lock button and disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      Tech Tips

      Tape the screwdriver tip before use.

    4. Remove the 4 bolts in the order shown in the illustration.

    5. Using needle-nose pliers, remove the 7 pins from the clip (A).

    6. Using 2 screwdrivers, detach the 7 clips (A) from the vehicle.

      Tech Tips

      Remove the clips (A) together with the curtain shield airbag assembly LH from the body.

    7. Remove the 2 clips (B) of the vehicle front side deployment portion.

    8. Remove the clip (B) of the vehicle rear side deployment portion.

    9. Detach the 2 clips (C) of the inflator and remove the curtain shield airbag assembly LH.

      B000YZIC01
      *1 Pin - -
      *a Vehicle Front Side Deployment Portion *b Vehicle Rear Side Deployment Portion
      *c Clip (A) *d Clip (B)
      *e Clip (C) - -

    10. Remove the 7 clips (A) from the curtain shield airbag assembly LH.