STEERING PAD INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL HORN BUTTON ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B000Y52

    3. Support the horn button assembly with one hand.

    4. B000ZC0C02
      *a Lock Button
      *b Wire Harness Clamp
      B000XM7 Airbag Connector
      B000YI8 Horn Connector
      B000WYJ Push

      Attach the wire harness clamp.

    5. Connect the 2 airbag connectors and lock the 2 lock buttons.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to connect the connectors to each corresponding color.

      • Make sure the lock button is securely locked.

    6. Connect the horn connector.

    7. Set the horn button assembly to the steering wheel assembly.

    8. Check that the airbag wire harness and horn wire harness are not pinched.

    9. B000YXZC01
      *a Upper Pin
      *b Lower Pin

      Press the horn button assembly with both hands to attach the upper springs.

    10. Press the horn button assembly with both hands to attach the lower spring.

      Note

      After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.

  2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

    B000V3J

    1. Attach the guide and claw to install the lower No. 3 steering wheel cover.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

    B000YK5

    1. Attach the guide and claw to install the lower No. 2 steering wheel cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. INSTALL NO. 2 DECK BOARD

    Click here

  6. INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system.

      Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here