COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here

  2. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  3. REMOVE METER HOOD SUB-ASSEMBLY

    Click here

  4. REMOVE COMBINATION METER ASSEMBLY


    1. B000UIJ

      Remove the 4 screws.

    2. B000W5KC01
      B000WCN Place Hand Here
      B000WYJ Remove in this Direction

      Detach the claws and guides as shown in the illustration.

    3. B000UZX

      Detach the wire harness clamps and disconnect the 2 connectors.

    4. B000Z5YC02
      B000WYJ Remove in this Direction

      Remove the combination meter assembly as shown in the illustration.

  5. REMOVE METER HOOD SPACER


    1. B000VDP

      Detach the claws and remove the meter hood spacer.