RADIO RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radio receiver removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Radio receiver assembly Re-install the eOwner's manual The eOwner's manual cannot be used -

Tech Tips


  • Use the same procedure as for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • After replacing the radio receiver assembly, if the "New software is not compatible with the system. Contact your dealer." on-screen message is displayed on the multi-display, update the software of the navigation ECU.

      Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  5. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    1. B000VA0C01
      B000WYJ Remove in this Direction

      Remove the 4 bolts.

    2. Pull out the radio receiver assembly with bracket.

    3. Detach the clamp as indicated by the arrows in the shown in the illustration.

    4. Disconnect the connectors and remove the radio receiver assembly with bracket.

  6. REMOVE NO. 1 NAVIGATION WIRE

    Click here

  7. REMOVE NO. 1 RADIO BRACKET


    1. B000UZC

      Remove the 5 screws and No. 1 radio bracket.

  8. REMOVE NO. 2 RADIO BRACKET


    1. B000UTE

      Remove the 5 screws and No. 2 radio bracket.

  9. REMOVE RADIO RECEIVER ASSEMBLY