ACTIVE NOISE CONTROL MICROPHONE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the active noise control microphone removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front Seat Assembly RH (Only for removal and installation)

  • Front Seat Assembly LH (Only for removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B000WAX

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    CAUTION:

    B000Y52

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Click here

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  5. REMOVE ACTIVE NOISE CONTROL MICROPHONE (for Front Side)


    1. B000Z8W

      for Glass Roof:


      1. Disconnect the connector.

      2. Detach the claws and remove the active noise control microphone.

    2. B000WXC

      for Carbon Roof:


      1. Disconnect the connector.

      2. Detach the claws and remove the active noise control microphone.

  6. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  7. REMOVE ACTIVE NOISE CONTROL MICROPHONE (for Rear Side)


    1. B000W44

      Detach the claws and remove the active noise control microphone.

  8. REMOVE MICROPHONE WIRE


    1. B000U0LC02
      *a Connector color: Black (microphone side)

      Disconnect the connector.

    2. Detach the clamps and remove the microphone wire.