AUDIO AND VISUAL SYSTEM, Diagnostic DTC:B153A

DTC Code DTC Name
B153A GVIF Disconnected (from Extension Module to H/U)

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B153A GVIF Disconnected (from Extension Module to H/U) GVIF disconnected (from navigation ECU to radio receiver assembly)
  • No. 1 navigation wire

  • Navigation ECU

  • Radio receiver assembly

WIRING DIAGRAM

B000TURE03
*a No. 1 Navigation Wire
*b Navigation ECU
*c Radio Receiver Assembly
*d GVIF Cable

CAUTION / NOTICE / HINT

Note

The following malfunctions may occur if a radio receiver assembly or navigation ECU from another vehicle is installed to this vehicle. Therefore, when replacing the radio receiver assembly or navigation ECU, be sure to replace them with new ones.


  • Communication malfunction DTC is output

  • Does not operate normally

Tech Tips

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
    2. Recheck for DTCs and check that no DTCs are output.


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK
    NG
  2. CHECK NO. 1 NAVIGATION WIRE (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. B000Y8YC03
      *a

      Front view of wire harness connector

      (to Navigation ECU)

      *b

      Front view of wire harness connector

      (to Radio Receiver Assembly)

      Disconnect the s2 radio receiver assembly connector.

    2. Disconnect the s1 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      s2-1 (GVIF-) - s1-1 (GVIF-) Always Below 1 Ω
      s2-2 (GVIF+) - s1-2 (GVIF+) Always Below 1 Ω
      s2-3 (GND) - s1-3 (GND) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. REPLACE NAVIGATION ECU


    1. Replace the Navigation ECU with a new one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  4. CHECK DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
    2. Recheck for DTCs and check that no DTCs are output.


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK
    NG