DYNAMIC REAR STEERING SYSTEM TEST MODE PROCEDURE


  1. TEST MODE

    Tech Tips

    When the system enters test mode, "DRS TEST MODE" is displayed on the multi-information display.


    1. Activate Test Mode.


      1. Turn the engine switch off.

      2. Connect the GTS to the DLC3.

      3. Turn the engine switch on (IG).

      4. Turn the GTS on.

      5. Enter the following menus: Chassis / DRS / Utility / Check Mode.


        Chassis > DRS > Utility
        Tester Display
        Check Mode

    2. End Test Mode.


      1. Turn the engine switch off.

      2. Connect the GTS to the DLC3.

      3. Turn the engine switch on (IG).

      4. Turn the GTS on.

      5. Switch the system from test mode to normal mode by following the directions on the GTS screen.