ELECTRIC PARKING BRAKE SYSTEM, Diagnostic DTC:C13A6/42

DTC Code DTC Name
C13A6/42 Open or Short in Circuit of Motor

DESCRIPTION

The parking brake cable tightening/loosening operation is performed by the parking brake actuator's motor.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C13A6/42 Open or Short in Circuit of Motor

Both of following conditions are met:


  1. Engine switch on (IG) or electric parking brake switch assembly pushed to lock side with engine switch off.

  2. Power supply voltage and +B voltage are normal, but motor circuit is malfunctioning for approximately 1 second.

  • Parking brake with bracket actuator assembly

  • Wire harness or connector

  • Parking brake ECU assembly

 Yes An electric parking brake system malfunction is displayed on the multi-information display.

WIRING DIAGRAM

B000VPCE03
*a Parking Brake with Bracket Actuator Assembly
*b Parking Brake ECU Assembly

CAUTION / NOTICE / HINT

Note


  • The electric parking brake may still operate up to 20 seconds after the engine switch is turned off. Before disconnecting connectors or fuses, turn the engine switch off and wait 20 seconds or more.

  • If the parking brake ECU assembly or parking brake with bracket actuator assembly is replaced, perform the "Reset Memory" and "Acquire Tension Sensor Zero Point" procedures.

    Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU ASSEMBLY - PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY)


    1. Turn the engine switch off.

    2. Disconnect the X66 parking brake ECU assembly connector.

    3. Disconnect the X68 parking brake with bracket actuator assembly connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      X66-1 (M-) - X68-7 (M-) Always Below 1 Ω
      X66-1 (M-) or X68-7 (M-) - Body ground Always 10 kΩ or higher
      X66-2 (M+) - X68-8 (M+) Always Below 1 Ω
      X66-2 (M+) or X68-8 (M+) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY (PARKING BRAKE MOTOR)


    1. Turn the engine switch off.

    2. B000V1VC03
      *a

      Component without harness connected

      (Parking Brake with Bracket Actuator Assembly)

      Disconnect the X68 parking brake with bracket actuator assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      7 (M-) - 8 (M+) Always Below 4 Ω
      7 (M-) - Body ground Always 10 kΩ or higher
      8 (M+) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE PARKING BRAKE ECU ASSEMBLY Click here

    NG

    REPLACE PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY Click here