PARKING BRAKE ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the parking brake assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

  • Rear disc (Including removal and installation)

  • Parking brake shoe (Including removal and installation)

 Parking brake bedding Electric parking brake system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  4. REMOVE REAR DISC LH

    Click here

  5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Rear Side)


    1. B000Y7ZN03

      Using SST, remove the parking brake shoe return tension spring.

      SST
      09703-30011

  6. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Front Side)


    1. B000YO0N02

      Using SST, remove the parking brake shoe return tension spring.

      SST
      09703-30011

  7. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET


    1. B000V1T

      Slide the parking brake shoe and remove the parking brake shoe adjusting screw set.

  8. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. B000UDAN02

      Using SST, remove the parking brake shoe hold down spring cup, parking brake shoe hold down compression spring and parking brake shoe hold down spring pin.

      SST
      09718-00011

    2. Remove the No. 2 parking brake shoe assembly LH.

  9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. B000U1MN02

      Using SST, remove the parking brake shoe hold down spring cup, parking brake shoe hold down compression spring and parking brake shoe hold down spring pin.

      SST
      09718-00011

    2. Remove the No. 1 parking brake shoe assembly LH.

  10. REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH


    1. B000VZ7

      Slide the parking brake shoe lever sub-assembly LH.

    2. B000WN8

      Separate the parking brake cable to remove the parking brake shoe lever sub-assembly LH.

  11. DISCONNECT PARKING BRAKE CABLE


    1. B000YEG

      Remove the nut and disconnect the parking brake cable.

  12. REMOVE PARKING BRAKE ANCHOR BLOCK SUB-ASSEMBLY


    1. Remove the rear axle hub and bearing assembly.

      Click here

    2. B000V10

      Remove the 2 nuts, cable support bracket and parking brake anchor block sub-assembly.