VSC OFF SWITCH INSPECTION

PROCEDURE


  1. INSPECT VSC OFF SWITCH (COMBINATION SWITCH ASSEMBLY)


    1. B000V9FC01
      *a

      Component without harness connected

      (VSC OFF Switch (Combination Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      8 (+) - 1 (E) Switch pushed Below 1 Ω
      Switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the VSC OFF switch (combination switch assembly).

    2. B000V9FC02
      *a

      Component without harness connected

      (VSC OFF Switch (Combination Switch Assembly))

      Apply battery voltage to the connector and check the illumination conditions.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 10 (ILL+)

      Battery negative (-) → 6 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the VSC OFF switch (combination switch assembly).