FRONT SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

PROCEDURE


  1. DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  2. REMOVE FRONT WHEEL

    Click here

  3. REMOVE FRONT SKID CONTROL SENSOR WIRE


    1. B000V7W

      Disconnect the front skid control sensor wire connector.

    2. Remove the bolt and sensor clamp.

    3. B000XXV

      Remove the nut and sensor clamp.

    4. B000YEU

      for LH Side:


      1. Disconnect the front skid control sensor wire connector.

      2. Remove the bolt and sensor clamp.

    5. B000X4F

      for RH Side:


      1. Disconnect the pad wear indicator connector.

      2. Disconnect the front skid control sensor wire connector.

      3. Remove the bolt and sensor clamp.

  4. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  5. REMOVE FRONT DISC LH

    Click here

  6. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Remove the front axle hub sub-assembly LH.

      Click here

      Tech Tips

      The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor malfunctions, replace the front axle hub sub-assembly.