STEERING ANGLE SENSOR

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA /LDA system	Click here
		Pre-collision system	Click here
		Parking assist monitor system	Click here
	Steering sensor zero point calibration	Variable gear ratio steering system	Click here
Steering sensor (Including removal and installation)	Steering angle neutral point (Initialize parking assist monitor system) Steering angle setting	Parking assist monitor system	for Initialization Click here for Calibration Click here

CAUTION / NOTICE / HINT

Note

If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral with sensor cable sub-assembly.

PROCEDURE

REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

Click here
REMOVE STEERING SENSOR
1. Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.
  
  Note
  
  Do not damage the claws and pins of the spiral cable sub-assembly.

STEERING ANGLE SENSOR REMOVAL