TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

   
   

   1. Connect the connector.

   2. Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver.

   3. Install the bolt.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

2. INSTALL INNER ROOF SIDE GARNISH RH

   Click here

3. INSTALL QUARTER TRIM PANEL ASSEMBLY RH

   Click here

4. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH

   Click here

5. INSTALL QUARTER INSIDE TRIM BOARD RH

   Click here

6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH

   Click here

7. INSTALL OUTER LAP BELT ANCHOR COVER

   Click here

8. INSTALL FRONT DOOR SCUFF PLATE RH

   Click here

9. INSTALL REAR SEATBACK ASSEMBLY RH

   Click here

10. INSTALL REAR SEATBACK COVER

    Click here

11. INSTALL REAR SEAT SIDE GARNISH

    Click here

12. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

13. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

14. INSTALL FRONT SEAT ASSEMBLY RH

    Click here

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

16. INSTALL NO. 2 DECK BOARD

    Click here

17. REGISTER TRANSMITTER ID

    Click here

18. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

19. PERFORM INITIALIZATION

    Click here