REAR LOWER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. B000YND

      Insert the rear suspension arm attachment sub-assembly from the back of the vehicle. Then temporarily tighten the rear No. 2 suspension toe adjust plate and rear No. 2 suspension arm assembly LH with the nut.

    2. B000V42

      Insert the bolt from the front of the vehicle. Then temporarily tighten the rear No. 2 suspension arm assembly LH with the nut.

  2. TEMPORARILY TIGHTEN REAR STABILIZER LINK ASSEMBLY LH


    1. B000VJ0

      Temporarily tighten the rear stabilizer link assembly LH to the rear No. 2 suspension arm assembly LH with the bolt and nut.

  3. CONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B000VMV

      Install the rear height control sensor sub-assembly LH to the rear No. 2 suspension arm assembly LH with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. TEMPORARILY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    1. B000XKN

      Insert the bolt from the back of the vehicle. Then temporarily tighten the lower control arm assembly LH with the nut.

    2. B000XCE

      Temporarily tighten the lower control arm assembly LH with a new nut.

  5. STABILIZE SUSPENSION

    Click here

  6. FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    1. B000XKN

      Fully tighten the lower control arm assembly LH with the bolt.

      Torque:
      126 N*m  { 1285 kgf*cm, 93 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

    2. B000XCE

      Fully tighten the nut.

      Torque:
      118 N*m  { 1203 kgf*cm, 87 ft.*lbf }

  7. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. B000YND

      Fully tighten the rear No. 2 suspension arm assembly LH with the nut.

      Torque:
      213 N*m  { 2172 kgf*cm, 157 ft.*lbf }
    2. B000V42

      Fully tighten the nut.

      Torque:
      165 N*m  { 1683 kgf*cm, 122 ft.*lbf }

  8. FULLY TIGHTEN REAR STABILIZER LINK ASSEMBLY LH


    1. B000VJ0

      Fully tighten the nut.

      Torque:
      24 N*m  { 245 kgf*cm, 18 ft.*lbf }

  9. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

    Click here

  10. INSTALL REAR WHEEL

    Click here

  11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  12. ADJUST HEADLIGHT AIMING

    Click here

  13. ADJUST REAR TELEVISION CAMERA ASSEMBLY OPTICAL AXIS

    Click here

  14. PERFORM DYNAMIC REAR STEERING SYSTEM CALIBRATION (w/ Dynamic Rear Steering)

    Click here