SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE

INSTALL ABSORBER CONTROL ECU
1. Install the absorber control ECU with the 2 nuts.
  
  Torque:
  
  7.5 N*m { 76 kgf*cm, 66 in.*lbf }
  Note
  - Avoid any impact to the absorber control ECU.
  - Do not drop the absorber control ECU. If it is dropped, replace it with a new one.
INSTALL REAR STEERING CONTROL ECU (w/ Dynamic Rear Steering)

Click here
INSTALL STEREO COMPONENT EQUALIZER ASSEMBLY (w/ Dynamic Rear Steering)

Click here
INSTALL NO. 2 DECK BOARD BRACKET
1. w/o Dynamic Rear Steering:
  1. Install the No. 2 deck board bracket with the 3 bolts.
    
    Torque:
    
    15.8 N*m { 161 kgf*cm, 12 ft.*lbf }
  2. Connect the 3 connectors.
2. w/ Dynamic Rear Steering:
  1. Install the No. 2 deck board bracket with the 3 bolts.
    
    Torque:
    
    15.8 N*m { 161 kgf*cm, 12 ft.*lbf }
  2. Connect the 3 connectors.
  3. *a Lock of the Lock Lever
    
    *b Lock Lever
    
    Connect the 3 connectors to the rear steering control ECU.
    
    Tech Tips
    
    When connecting the connector with lock lever, return the lock lever to its original position and securely push in the lock of the lock lever as shown in the illustration.
INSTALL INNER LUGGAGE COMPARTMENT TRIM COVER RH

Click here
INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

Click here
INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Click here
INSTALL REAR FLOOR FINISH PLATE

Click here
INSTALL SIDE TRIM BOX

Click here
INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

Click here
INSTALL NO. 1 DECK BOARD

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here
Note
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
- After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.
  
  Click here
INSTALL NO. 2 DECK BOARD

Click here

*a	Lock of the Lock Lever
*b	Lock Lever