HEIGHT CONTROL SENSOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear height control sensor sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA system	Click here
		Pre-collision system	Click here
		Parking assist monitor system	Click here
	Steering sensor zero point calibration	Variable gear ratio steering system	Click here

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE NO. 2 DECK BOARD

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click here

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE REAR WHEEL LH

Click here
REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
1. *a Matchmark
  
  Place matchmarks on the height control sensor link and load sensing valve sensor bracket.
2. Remove the nut and separate the height control sensor link from the load sensing valve sensor bracket.
3. Disconnect the connector.
4. Remove the 2 bolts and rear height control sensor sub-assembly LH.
  
  Note
  
  Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.
REMOVE LOAD SENSING VALVE SENSOR BRACKET
1. Remove the bolt and load sensing valve sensor bracket from the No.2 rear suspension arm LH.