HEIGHT CONTROL SENSOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front height control sensor sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT WHEEL LH

    Click here

  5. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B000UMT

      Remove the bolt.

    2. B000XYF

      Remove the bolt and separate the height control sensor link from the No.2 front suspension lower arm LH.

    3. B000UFR

      Disconnect the connector.

    4. Remove the bolt.

    5. Disengage the clamp.

    6. B000XJ6

      Remove the 2 bolts and rear height control sensor sub-assembly LH.

      Note

      Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.