FRONT ACCELERATION SENSOR INSTALLATION

PROCEDURE

1. INSTALL ACCELERATION SENSOR

   
   

   1. for LH side:

      
      

      1. Install the acceleration sensor with the 2 nuts.

         Torque:

         5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

         Note

         
         

         • Avoid any impact to the acceleration sensor.

         • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.

      2. Connect the connector.

      3. Return the floor carpet to its original position.

   2. for RH side:

      
      

      1. Install the acceleration sensor with the 2 nuts.

         Torque:

         5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

         Note

         
         

         • Avoid any impact to the acceleration sensor.

         • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.

      2. Connect the connector.

      3. Return the floor carpet to its original position.

2. INSTALL FRONT DOOR OPENING TRIM COVER LH

   Click here

3. INSTALL FRONT DOOR OPENING TRIM COVER RH

   Click here

4. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

5. INSTALL FRONT DOOR SCUFF PLATE RH

   Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note

   
   

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

     Click here

   • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

     Click here

7. INSTALL NO. 2 DECK BOARD

   Click here