REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    Note


    • Do not damage the installation surface when installing the rear differential carrier assembly.

    • The remaining oil may leak out when installing the rear differential carrier assembly.

    • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

    • Install the bolts with the rear differential carrier assembly secured.


    1. B000YOEN02

      Support the rear differential carrier assembly with a transmission jack.

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

    2. B000UAFC01
      *1 Rear Upper Differential Mount Stopper
      *2 Rear Lower Differential Mount Stopper
      B000XM7 Upper of the Vehicle

      Install the 2 rear upper differential mount stoppers to the rear differential carrier assembly.

      Note

      Be careful of the rear surface of the rear differential upper mount stopper and rear differential lower mount stopper.

    3. Temporarily install the rear differential carrier assembly to the rear suspension member sub-assembly with the 2 rear lower differential mount stoppers and 2 new bolts (A).

    4. Using a 12 mm socket hexagon wrench, temporarily install the rear differential carrier assembly and rear differential dynamic damper to the rear suspension member sub-assembly with 2 new bolts (B).

      Tech Tips

      Before installing the bolts (B), make sure that there is no clearance between the rear differential carrier assembly and rear differential mount cushion.

    5. Using a 12 mm socket hexagon wrench, tighten the 2 bolts (B).

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

      Note

      Do not tilt the sleeve or deform the rubber of the mount when tightening the bolts (B).

    6. Tighten the 2 bolts (A).

      Torque:
      88.9 N*m  { 907 kgf*cm, 66 ft.*lbf }

      Note

      Do not tilt the sleeve or deform the rubber of the mount when tightening the bolts (A).

  2. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  3. INSTALL REAR DRIVE SHAFT ASSEMBLY


    1. Install the rear drive shaft assembly LH and rear drive shaft assembly RH.

      Click here

  4. ADD DIFFERENTIAL OIL

    Click here