SHIFT PADDLE SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL NO. 2 SWITCH WIRE (w/ Steering Heater)


    1. Connect the 2 guides and install the No. 2 switch wire to the lower steering wheel boss cover.

      B000VQXC01
      *a No. 2 Switch Wire Harness Junction *b No. 2 Switch Wire Blue Connector
      *c Front side *d Back side

      Note


      • Install the No. 2 switch wire harness junction so that it is inside the left guide as shown in the illustration.

      • Install the blue connector of the No. 2 switch wire to the transmission shift switch LH.

  2. INSTALL NO. 2 SWITCH WIRE (w/o Steering Heater)


    1. B000VZ5C01
      *a No. 2 Switch Wire Harness Junction
      *b No. 2 Switch Wire Blue Connector

      Connect the 2 guides and install the No. 2 switch wire to the lower steering wheel boss cover.

      Note

      Install the No. 2 switch wire harness junction so that it is inside the left guide as shown in the illustration.

  3. CONNECT LOWER STEERING WHEEL BOSS COVER (w/ Steering Heater)

    Click here

  4. INSTALL LOWER STEERING WHEEL BOSS COVER (w/o Steering Heater)

    Click here

  5. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. for transmission shift switch assembly LH side:


      1. B000WJR

        Connect the connector of the No. 2 switch wire to the transmission shift switch assembly.

      2. B000W07C01
        *a Protrusion
        *b Guide

        Align the 3 protrusions on the transmission shift switch with the 3 guides on the steering wheel assembly and lower steering wheel boss cover.

      3. B000WWIC02
        *1 Transmission Shift Switch Assembly
        *2 No. 2 Switch Wire
        *a Guide
        B000WYJ Push in perpendicular

        Push in the transmission shift switch assembly into the steering wheel assembly perpendicular, attach the 2 guides and No. 2 switch wire to the guide and install the transmission shift switch assembly to the steering wheel assembly.

    2. for transmission shift switch assembly RH side:


      1. B000WN4

        Connect the connector of the No. 2 switch wire to the transmission shift switch assembly.

      2. B000W83C01
        *a Protrusion
        *b Guide

        Align the 3 protrusions on the transmission shift switch with the 3 guides on the steering wheel assembly and lower steering wheel boss cover.

      3. B000WDDC01
        *1 Transmission Shift Switch Assembly
        *2 No. 2 Switch Wire
        *a Guide
        B000WYJ Push in perpendicular

        Push in the transmission shift switch assembly into the steering wheel assembly perpendicular, attach the 2 guides and No. 2 switch wire to the guide and install the transmission shift switch assembly to the steering wheel assembly.

    3. Check the installation condition of the No. 2 switch wire.

      B000Z5BC01
      *a OK *b NG
      *c Does not protrude - -

      Note

      Make sure that the No. 2 switch wire does not stick out from the lower steering wheel boss cover.

    4. B000V9U

      Connect the 2 transmission shift switch assemblies with the 2 screws.

  6. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  7. INSTALL STEERING WHEEL ASSEMBLY

    Click here