SHIFT CONTROL ACTUATOR INSTALLATION

PROCEDURE


  1. INSTALL SHIFT CONTROL ACTUATOR ASSEMBLY

    Note

    If the shift control actuator assembly is removed, replace the shift control actuator seal.


    1. Apply ATF WS around the outside edge of the case press-fit surface of the automatic transmission assembly

    2. Coat the lip of a new shift control actuator seal with a small amount of MP grease.

    3. B000W1AN01

      Using SST and hammer, install the shift control actuator seal to the automatic transmission assembly.

      SST
      09350-30020   ( 09350-07110 )
      Shift Control Actuator Seal Installation Depth
      6.5 to 7.3 mm (0.256 to 0.287 in.)

      Note

      Install the shift control actuator seal so that the white marking faces the outside of the automatic transmission assembly.

    4. B000U87

      Install the bracket to the shift control actuator assembly with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    5. B000TRHC01
      B000XM7 Bolt A
      B000TT4 Bolt B

      Install the shift control actuator assembly to the automatic transmission assembly with the 3 bolts.

      Torque:
      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note

      Clean and degrease the threads of the automatic transmission assembly side bolt holes.

      Tech Tips

      As the position of the shift control actuator assembly is detected automatically, initialization is not necessary after disconnecting and reconnecting the cable to the negative (-) battery terminal.

      Item Length
      Bolt A 22 mm (0.866 in.)
      Bolt B 40 mm (1.57 in.)
    6. B000UAXC01
      B000XM7 Bolt
      B000TT4 Nut and Spring Washer

      Connect the throttle link connecting rod assembly to the shift control actuator assembly with the nut, spring washer and 2 bolts.

      Torque:
      for bolt
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
      for nut
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }
    7. B000Z0Y

      Connect the 2 connectors and attach the clamp.

    8. Raise the automatic transmission assembly to a position where the engine rear mounting member bolt can be installed.

    9. B000UFH

      Install the 6 bolts to the engine rear mounting member.

      Torque:
      34.7 N*m  { 354 kgf*cm, 26 ft.*lbf }

    10. Remove the transmission jack.

  2. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here