FRONT DOOR COURTESY SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE COURTESY LIGHT SWITCH


    1. B000WV9

      Using a T30 "TORX" socket wrench, remove the "TORX" screw.

      Note

      The "TORX" screw must not be reused.

    2. Pull out the courtesy light switch.

      Note

      Pulling the courtesy light switch out too far may damage the connector and wire harness. Therefore, make sure to only pull it out far enough so that the connector can be disconnected.

    3. Cover the application hole on the body with tape to prevent the wire harness from falling into the vehicle.

    4. Disconnect the connector.

      B000YY8C01
      B000WCG Tape to prevent wire harness from falling B000WYJ Remove in this Direction