DYNAMIC RADAR CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION

The ECM illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using GTS:


  • Before using the GTS, read the instruction GTS.

  • Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

  • When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.

Note

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Click here


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Meter Display 1 Multi-information display OFF or All Test possible with engine switch on (IG), vehicle stopped

      Body Electrical > Combination Meter > Active Test
      Tester Display
      Meter Display 1
      Result
      Result Proceed to
      The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. A
      The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. B

    B

    GO TO METER / GAUGE SYSTEM Click here

    A

  2. READ VALUE USING GTS (-SET SWITCH)


    1. Turn the cruise control system on using the cruise control main switch.

    2. w/o Full-speed range following function:

      Drive at a speed between approximately 50 km/h (31 mph) or higher.

    3. w/ Full-speed range following function:

      Drive at a speed between approximately 0 km/h (0 mph) or higher.

    4. Enter the following menus: Powertrain / Radar Cruise 1 / Data List.

    5. Read the Data List according to the display on the GTS.

      Click here


      Powertrain > Radar Cruise1 > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      -SET Switch -SET switch status ON or OFF

      ON: -SET switch pushed

      OFF: -SET switch not pushed

      		 -

      Powertrain > Radar Cruise1 > Data List
      Tester Display
      Cruise Indicator
      Result
      Result Proceed to
      The cruise control SET indicator illuminates and turns off according to the operation of the -SET switch. A
      The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the -SET switch. B
      The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the -SET switch. C

    A

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    B

    REPLACE COMBINATION METER ASSEMBLY Click here

    C

    REPLACE ECM Click here