CRUISE CONTROL SYSTEM Cruise Main Indicator Light Circuit

DESCRIPTION

The ECM illuminates the cruise control indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control indicator illuminates when the cruise control system is turned on using the cruise control main switch. If a malfunction is detected, the cruise control indicator turns off and a warning message is displayed. The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Meter Display 1 Multi-information display OFF or All Test possible with engine switch on (IG), vehicle stopped

      Body Electrical > Combination Meter > Active Test
      Tester Display
      Meter Display 1
      Result
      Result Proceed to
      The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. A
      The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. B

    B

    GO TO METER / GAUGE SYSTEM Click here

    A

  2. READ VALUE USING GTS (CRUISE INDICATOR)


    1. Enter the following menus: Powertrain / Cruise Control / Data List.

    2. Read the Data List according to the display on the GTS.

      Click here


      Powertrain > Cruise Control > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Cruise Indicator Cruise control indicator light signal ON or OFF

      ON: Cruise control indicator illuminates

      OFF: Cruise control indicator turns off

      		 -

      Powertrain > Cruise Control > Data List
      Tester Display
      Cruise Indicator
      Result
      Result Proceed to
      The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch. A
      The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch. B
      The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch. C

    A

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    B

    REPLACE COMBINATION METER ASSEMBLY Click here

    C

    REPLACE ECM Click here