STARTER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL FLYWHEEL HOUSING SIDE COVER


    1. B000UZAC01
      B000WYJ Install in this Direction

      Install the flywheel housing side cover as shown in the illustration.

  2. INSTALL STARTER ASSEMBLY


    1. B000W5U

      Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    2. B000WUZC04
      *1 Terminal Cover
      *a Nut A
      *b Nut B
      *c Connector

      Install the terminal cover with the nut A.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the starter wire with the nut B.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Close the terminal cover.

    5. Connect the starter assembly connector.

  3. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    1. B000YLM

      Install the No. 3 exhaust manifold heat insulator with the 3 bolts.

      Torque:
      11.5 N*m  { 117 kgf*cm, 8 ft.*lbf }

  4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. INSTALL NO. 2 DECK BOARD

    Click here