STARTER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

    Click here

  5. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    1. B000YLM

      Remove the 3 bolts and No. 3 exhaust manifold heat insulator.

  6. REMOVE STARTER ASSEMBLY


    1. B000WUZC05
      *1 Terminal Cover
      *a Connector
      *b Nut A
      *c Nut B

      Disconnect the starter assembly connector.

    2. Open the terminal cover.

    3. Remove the nut A to disconnect the starter wire.

    4. Remove the nut B and terminal cover.

    5. B000W5U

      Remove the 2 bolts and starter assembly.

  7. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. B000VVGC01
      B000WYJ Remove in this Direction

      Remove the flywheel housing side cover as shown in the illustration.