EXHAUST CHANGE VALVE DRIVER INSTALLATION

PROCEDURE

1. INSTALL EXHAUST CHANGE VALVE DRIVER

   
   

   1. Install 2 exhaust change valve drivers to the No. 3 deck board with the 2 nuts.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

   2. Connect the 2 connectors to the 2 exhaust change valve drivers.

2. INSTALL INNER LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

3. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

   Click here

4. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

   Click here

5. INSTALL LUGGAGE COMPARTMENT TRIM BOX

   Click here

6. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

7. INSTALL REAR FLOOR FINISH PLATE

   Click here

8. INSTALL NO. 1 DECK BOARD

   Click here

9. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

10. INSTALL NO. 2 DECK BOARD

    Click here