FUEL PUMP ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pump control ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA /LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

PROCEDURE


  1. REMOVE BRAKE CONTROL POWER SUPPLY WITH BRACKET ASSEMBLY

    Click here

  2. REMOVE FUEL PUMP CONTROL ECU


    1. B000XSB

      Disconnect the 2 fuel pump control ECU assembly connectors.

  3. REMOVE FUEL PUMP CONTROL ECU BRACKET


    1. B000U3E

      Remove the 3 bolts and fuel pump control ECU assembly from the fuel pump control ECU bracket.