FUEL INJECTOR(for Direct Injection) INSPECTION

PROCEDURE


  1. INSPECT DIRECT FUEL INJECTOR ASSEMBLY

    Note

    This inspection aims at checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assemblies of this vehicle are a high-pressure type, fuel injection volume cannot be checked.


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 1.74 to 2.04 Ω

      If the result is not as specified, replace the direct fuel injector assembly.