REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL ENGINE REAR OIL SEAL


    1. Apply MP grease to the lip of a new engine rear oil seal.

    2. B000USKC01
      *a Oil Seal Protrusion Height

      Using SST and a hammer, tap in the engine rear oil seal.

      SST
      09223-15030
      Oil Seal Protrusion Height
      -1.0 to 0 mm (-0.0394 to 0 in.) (From the edge of the engine rear oil seal retainer)

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the engine rear oil seal at an angle.

      • Do not tap in the engine rear oil seal excessively.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. B000U8HN01

      Using SST, hold the crankshaft pulley.

      SST
      09213-38010   ( 09214-00011 )
      09330-00021

    2. Clean the 10 bolt holes.

    3. B000WW0C01
      *a Pin Hole
      *b Pin
      B000XM7 Engine Front

      Install the crankshaft angle sensor rotor.

      Tech Tips

      Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.

    4. B000ZD4C01
      *1 Drive Plate
      *2 Rear Drive Plate Spacer
      B000XM7 Automatic Transmission Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

      Tech Tips

      As the drive plate and ring gear sub-assembly and the rear drive plate spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    5. B000X0BC92
      *a Adhesive

      Apply a few drops of adhesive to 2 or 3 threads at the tip of each of 10 new bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note


      • Do not reuse the drive plate installation bolts.

      • To prevent contamination by foreign matter, install immediately after applying adhesive.

    6. B000UQMN02

      Install and uniformly tighten the 10 new bolts in the sequence shown in the illustration.

      Torque:
      29.5 N*m  { 301 kgf*cm, 22 ft.*lbf }

      Note


      • Handle the drive plate installation bolts carefully. Do not scratch them or subject them to any shocks.

      • Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

    7. Mark the upside of each drive plate and ring gear sub-assembly installation bolt with paint.

    8. Tighten the drive plate and ring gear sub-assembly installation bolts another 90° as shown in the illustration.

    9. B000YTSC03
      *a Paint Mark
      B000TT4 Up

      Check that the paint marks are now at 90° angle.

  3. INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

    Click here

  4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  5. INSPECT FOR ENGINE OIL LEAK

    Click here