HEATED OXYGEN SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Heated oxygen sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

w/ Canister Pump Module: Click here

PROCEDURE


  1. REMOVE REAR FLOOR SIDE MEMBER COVER LH

    Click here

  2. REMOVE REAR FLOOR SIDE MEMBER COVER RH

    Click here

  3. REMOVE FRONT FENDER SEAL LH

    Click here

  4. REMOVE FRONT FENDER SEAL RH

    Click here

  5. REMOVE FRONT FLOOR COVER LH

    Click here

  6. REMOVE FRONT FLOOR COVER RH

    Click here

  7. REMOVE FRONT SEAT ASSEMBLY

    Click here

  8. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR


    1. B000UNXC01
      *A for Bank 1
      *B for Bank 2

      Fold back the floor carpet.

    2. Disconnect the 2 heated oxygen sensor connectors.

  9. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    1. B000XZ7N01

      Detach the heated oxygen sensor grommet and clamp from the vehicle body.

    2. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00012

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

  10. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    1. B000XGWN01

      Detach the heated oxygen sensor grommet and clamp from the vehicle body.

    2. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00012

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.