KNOCK SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Perform "Inspection After Repair" after replacing a knock control sensor.


PROCEDURE


  1. INSTALL KNOCK CONTROL SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing a knock control sensor.



    1. B000Z4OC02
      *A for Bank 2 Sensor 1
      *B for Bank 2 Sensor 2
      *C for Bank 1 Sensor 1
      *D for Bank 1 Sensor 2
      *a Up
      B000TT4 Engine Front

      Install the 4 knock control sensors to the cylinder block sub-assembly with the 4 bolts so that the knock control sensor installation position is as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • Make sure that each knock control sensor is in the correct position.

      • If a knock control sensor has been struck or dropped, replace it.

    2. Connect the 4 knock control sensor connectors.

  2. INSTALL CASE SEPARATOR


    1. Install the case separator with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the fuel pressure sensor connector.

  3. INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY LH

    Click here

  5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  6. INSTALL INTAKE AIR SURGE TANK ASSEMBLY

    Click here