DOOR CONTROL RECEIVER(for RH Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door control receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Electrical key and tire pressure monitoring system receiver assembly

  • Register transmitter ID

  • Initialize tire pressure warning system

  • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

  • Tire pressure warning function

for Initialization Click here

for Registration Click here

Front seat assembly RH (Only for removal and installation) Initialize position control ECU Front Power Seat Control System

Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B000WAX

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  3. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  4. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  5. REMOVE REAR SEAT SIDE GARNISH

    Click here

  6. REMOVE REAR SEATBACK COVER

    Click here

  7. REMOVE REAR SEATBACK ASSEMBLY RH

    Click here

  8. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  9. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  11. REMOVE QUARTER INSIDE TRIM BOARD RH

    Click here

  12. REMOVE REAR SEAT INNER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure for the rear seat No. 1 inner belt assembly LH.

    Click here

  13. REMOVE QUARTER TRIM PANEL ASSEMBLY RH

    Click here

  14. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  15. REMOVE ELECTRICAL KEY AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY


    1. B000VJJ

      Disconnect the connector.

    2. Remove the bolt.

    3. Disengage the guides to remove the electrical key and tire pressure monitoring system receiver assembly.