DOOR CONTROL RECEIVER(for RH Side) INSTALLATION

PROCEDURE

1. INSTALL ELECTRICAL KEY AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY

   
   

   1. Attach the guides.

   2. Install the electrical key and tire pressure monitoring system receiver assembly with the bolt.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

   3. Connect the connector.

2. INSTALL INNER ROOF SIDE GARNISH RH

   Click here

3. INSTALL QUARTER TRIM PANEL ASSEMBLY RH

   Click here

4. INSTALL REAR SEAT INNER BELT ASSEMBLY RH

   Tech Tips

   Use the same procedure for the rear No. 1 seat inner belt assembly LH

   Click here

5. INSTALL QUARTER INSIDE TRIM BOARD RH

   Click here

6. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH

   Tech Tips

   Use the same procedure described for the LH side.

   Click here

7. INSTALL OUTER LAP BELT ANCHOR COVER

   Click here

8. INSTALL FRONT DOOR SCUFF PLATE RH

   Click here

9. INSTALL REAR SEATBACK ASSEMBLY RH

   Click here

10. INSTALL REAR SEATBACK COVER

    Click here

11. INSTALL REAR SEAT SIDE GARNISH

    Click here

12. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

13. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

14. INSTALL FRONT SEAT ASSEMBLY RH

    Click here

15. INITIALIZATION OF SEAT ECU

    Click here

16. REGISTER TRANSMITTER ID

    Click here

17. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

18. PERFORM INITIALIZATION

    Click here

19. INSPECT SRS WARNING LIGHT

    Click here