DOOR CONTROL RECEIVER(for LH Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door control receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Front seat assembly LH (Only for removal and installation) Initialize position control ECU Front Power Seat Control System

Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B000WAX

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  3. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  4. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  5. REMOVE REAR SEAT SIDE GARNISH

    Click here

  6. REMOVE REAR SEATBACK COVER

    Click here

  7. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  8. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  9. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH(FLOOR ANCHOR)

    Click here

  11. REMOVE QUARTER INSIDE TRIM BOARD LH

    Click here

  12. REMOVE REAR NO.1 SEAT INNER BELT ASSEMBLY LH

    Click here

  13. REMOVE QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  14. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  15. REMOVE DOOR CONTROL RECEIVER


    1. B000UGAC01
      B000XM7 Bolt
      B000TT4 Connector

      Disconnect the connector.

    2. Remove the bolt.

    3. Detach the guides and remove the door control receiver.