CLEARANCE WARNING BUZZER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. INSTALL NO. 1 CLEARANCE WARNING BUZZER


    1. Attach the clamp to install the No. 1 clearance warning buzzer.

    2. Connect the connector.

  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)

    Click here

  3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT DOOR NO. 2 OPENING TRIM COVER LH

    Click here

  7. INSTALL FRONT DOOR OPENING TRIM COVER LH

    Click here

  8. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  9. INSTALL BOX PANEL SUB-ASSEMBLY

    Click here

  10. INSTALL UPPER CONSOLE BOX

    Click here

  11. INSTALL SHIFTING HOLE COVER ASSEMBLY

    Click here

  12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  13. INSTALL RADIO REMOTE TUNING SWITCH ASSEMBLY

    Click here

  14. INSTALL REAR CONSOLE BOX POCKET

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for LHD)

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  16. INSTALL NO. 2 DECK BOARD (for LHD)

    Click here

  17. PERFORM DIAGNOSTIC SYSTEM CHECK (for LHD)

    Click here

  18. CHECK SRS WARNING LIGHT (for LHD)

    Click here