TELEVISION CAMERA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Television camera assembly (Only for removal and installation) Television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click here

Television camera assembly Parking assist monitor system initialization
Active rear wing assembly (Including removal and installation) Initialization Active rear wing system

Click here

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP

    Click here

  2. REMOVE LUGGAGE COMPARTMENT DOOR COVER

    Click here

  3. REMOVE ACTIVE REAR WING (w/ Active Rear Wing)

    Click here

  4. REMOVE TELEVISION CAMERA ASSEMBLY


    1. B000Z9B

      Disconnect the connector.

    2. Disconnect the wire harness clamp.

    3. B000W4JC01
      B000WYJ Remove in this Direction

      Remove the 2 screws.

    4. Detach the clip and remove the television camera assembly.