DATA LIST
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / IPA / Parking Assist Monitor / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| HV/ENG Data Check | Verification of the HV/ENG data | OK or NG | OK: Data verification normal NG: Data verification abnormal |
- |
| 2WD/4WD Data Check | Verification of 2WD/4WD data | OK or NG | OK: Data verification normal NG: Data verification abnormal |
- |
| Destination Data Check | Verification of destination data | OK or NG | OK: Data verification normal NG: Data verification abnormal |
- |
| RHD/LHD Signal Check | Verification of RHD/LHD signal | OK or NG | OK: Data verification normal NG: Data verification abnormal |
- |
| VGRS With or Without Status (Back Camera) | Displays "television camera assembly's internal data may or may not match the "with/without VGRS" data that has been input" | OK or NG | OK: Data verification normal NG: Data verification abnormal |
- |
| EEPROM Status (Initial read) | Television camera assembly information | OK or NG | OK: Television camera assembly normal NG: Television camera assembly abnormal |
- |
| Parking Assist Function of Camera | Television camera assembly ECU condition | Valid or Invalid | Valid: Television camera assembly ECU operating Invalid: Television camera assembly ECU not operating |
- |
| VGRS Relative Angle Status | Displays "VGRS may be active or inactive" | OK or NG | OK: VGRS normal NG: VGRS abnormal |
- |
| Number of DTC | Number of stored DTCs | min.: 0, max.: 255 | Number of DTCs will be displayed | - |
| Current Key Cycle | Cumulative number of times the engine switch was turned on (IG) | Min.: 0, Max.: 65535 time | Cumulative number of times the power was turned on (IG) will be displayed | - |
| Current Key Cycle Elapsed Time | Time elapsed since the engine switch was turned on (IG) | Min.: 0, Max.: 53687091.1 s | Time elapsed since the engine switch was turned on (IG) will be displayed | - |