PARKING ASSIST MONITOR SYSTEM PRECAUTION


  1. POINTS TO NOTE WHEN SERVICING


    1. Pay attention to the following points when servicing.


      1. When disconnecting the cable from the negative (-) battery terminal, "System initializing" may appear on the multi-display. In this case, correct the steering angle neutral point.

        Click here

      2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

        Click here

        Tech Tips

        Each adjusted value for the calibration of the parking assist monitor system will be stored in the radio receiver assembly.

      3. A clear image may not be displayed if there is foreign matter such as water drops, snow or mud on the rear television camera lens. In such a case, wash the lens with a large amount of water and then wipe it with a soft wet cloth. Do not scrub the camera lens as scrubbing may scratch the camera lens and affect the quality of the image.

  2. NOTES FOR TELEVISION CAMERA ASSEMBLY


    1. Notes for the television camera assembly


      1. The parking assist monitor system may not function properly if subjected to a severe blow by any hard object.

      2. The cover part of the camera is made of resin. If any organic solvent, degreaser, wax or glass coating contacts the cover, immediately wipe it off and wash the cover with water or cracks may develop.

      3. Exposing the camera to a sudden temperature change may affect proper functioning of the camera.

      4. A clear image may not be displayed if there is foreign matter such as water drops, snow or mud on the television camera lens. In such a case, wash the lens with a large amount of water and then wipe it with a soft wet cloth. Do not scrub the camera lens as scrubbing may scratch the camera lens and affect the quality of the image.

      5. When washing the vehicle with a high-pressure washer, do not spray water on the television camera assembly or surrounding area. High-pressure water can damage the camera.

    2. Images may be unclear even in normal conditions if:


      1. Electrical devices are used in the cabin (noise may occur in the image).

      2. Accessories that generate radio waves have been installed (noise may occur in the image).

      3. The multi-display is cold (the image immediately after turning the engine switch on (IG) may be blurred or darker than normal).

      4. The camera lens is dirty with snow, mud, etc.

      5. A strong beam of light, such as a sunbeam or headlight, hits the camera.

      6. It is too dark around the camera (at night, etc.).

      7. The ambient temperature around the camera is either too high or too low.

      8. The vehicle is tilted at a steep angle.

      9. The television camera assembly lens is scratched.

      10. The television camera assembly lens has drops of water on it or the humidity is high.

      11. When the camera is used under fluorescent lights, sodium lights, mercury lights, etc., the lights and the illuminated area may appear to flicker.